Metal shredding machine at work is the most important thing in the inside of the fan and fixed rotor, although is a widget is a bad soon, zhengzhou shuguang heavy industry to everyone listed below are fault and solution:
1. In the metal shredding machine will take a long time when the inside of the bearing excessive wear, caused by the friction between stator iron core surface damage, can cause a short-circuit motor iron loss increase so that the temperature of the motor, immediately with smooth file tools to remove the burr, clean off between silicon steel sheet sub clean smear insulating paint again after the last heating drying. 2. Metal shredding machine if the force is too large, need to dismantle winding stolen slot will skew or outward open, long nose pliers, wooden hammer at this time should be used the repair tools to repair, can make the tooth back in situ, at the same time also to be in a bad place and there is gap between silicon steel sheet in plus insulation board of the green shell paper, glue.
Sometimes the iron core surface is rust because of the weather.
4. It is also necessary to remove the burnt iron core or the tooth part with a chisel or a scraper, which can be cleaned and removed, as well as the scraped insulator and dried after cleaning.
5. It is found that the machine seat and iron core need to fix the screws immediately when they are loose. If the screws are fixed, the screws can be redrilled in the seat.
Above is zhengzhou shuguang heavy industry based on past experience of technical staff feedback summarizes this time, these are just some more common faults, may not particularly perfect, hope you are for reference only. Zhengzhou shuguang heavy industry professional production metal shredder, our production of metal shredder equipment quality good, the price is reasonable. Welcome to buy and buy.
Related Products
Email
Telephone
Leave Message
