6. When the machine is running, the operator must not leave the unit, nor disassemble the machine during operation to observe the working condition in the crushing room. The maintenance tools must not be placed on the machine.
7. The operator should not wear gloves. When the blockage occurs, it is strictly forbidden to put the hand into the packing. When feeding, stand on the side of the crusher to prevent the rebound debris from injuring the face.
8. Do not stop immediately after the work is finished. It should be idle for 2-3 minutes to allow all the materials in the machine to be discharged. Cleaning and maintenance work should be carried out after shutdown.
9. The hammer of the aluminum shredder is the main wearing part. After the wear, whether it is the same direction or the angle of the head, the whole set of hammers should be exchanged at the same time. When replacing the new hammer, the whole set of hammers should be replaced at the same time.The screen is also a wearing part. If some of the screen is damaged, it can be riveted. If it is badly damaged, it needs to be replaced with a new one.
10. After the aluminum shredder has been working for 300 hours, it is necessary to clean the bearings and replace the oil. The belt should be removed when the machine is stopped for a long time.
The business scope of Shuguang has covered the fields of recycling, crushing and sorting of waste aluminum products,scrap metal, tires, plastics, wood, glass, paper products, wire and cable, and home appliance casings.
Factory Address: Longjiang West Road, Shangjie District, Zhengzhou City
Contact number: +86-371-67666660 676667
Mobile phone: 0086 13523465141
After-sales Service Department: 0371-67666667
Related Products
Email
Telephone
Leave Message
