Installationofreducerforplasticindustrialshredder.

The installation method of the reducer of the plastic industrial shredder is as follows:

The first step

Tore up before installation, make sure the plastics industry and mechanical and electrical machine and plastic industry shredding machine speed reducer are intact, and strict inspection of motor and reducer connected parts size matches, here is the positioning convex sets, input shaft of the motor and reducer groove size and tolerance, etc.

The second step

Screw the screw on the outer dustp roof hole on the outside of the reducer flange of the plastic industrial shredder, adjust the clamp ring of the PCS system to align the side hole and the dustp roof hole, insert the inner hexagon screw. After that, take the motor shaft key.

The third step

Plastic industrial shredder and plastic industrial shredder natural connection. When connecting, it is necessary to ensure that the output shaft of the reducer is consistent with the input shaft of the motor, and the outer flange is parallel. If the concentricity is inconsistent, it will cause the motor shaft to break or gear gear wear.